Moen S0003 Przewodnik Instalacji Pobierz pdf

MT021A

(78397)

Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nut is in place. The cartridge and

retainer nut were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through

the handling of the valve by any number of persons the retainer nut may not be properly installed. This should be carefully checked at

time of rough-in and trim-out. If the retainer nut is not properly installed, water pressure could force the cartridge out of the casting.

Personal injury or water damage to the premises could result.

CAUTION:

Always turn water off before disassembling the valve. Open both faucet handles to

alleviate water pressure to insure that complete water shut-off has been accomplished.

by MOEN

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE

LEFT AT INSTALLATION SITE

SANI-STREAM

FRICTION WASHER

Installation:

1. Thoroughly grease spout o-rings with grease pack provided.

Insert spout into faucet with a twisting motion.

(Not

e: I

f stationar

y sp

out is desir

ed, install friction washer into faucet outlet before inserting spout).

igh

en spout nut.

4. Flush the spout of any dirt or foreign material by removing the aerator and slowly turning on both hot and and cold supplies.

eplace aerator.

NOTE: For double jointed spout part number S0012, grease the o-rings in both the upper and lower joints.

1 2

MT021A(78397)Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nut is in place. The cartridge andreta

Brak uwag

Moen S0003 Przewodnik Instalacji